Tag: Post-Production Equipment
-
Plant Shutdown
Planning a shutdown for an injection molding plant is a complex task that requires careful planning and preparation to minimize downtime, maintain productivity, and ensure safety as well as ensure equipment, materials, and processes are properly secured and preserved.
-
Prepare Your Shop for Winter
Preparing an injection molding shop for the cold winter months requires both practical and strategic measures to ensure the machines and processes run efficiently despite the drop in temperature. Here are suggestions of actions you can take now. 1. Temperature Control Inspect doors, windows, and walls for drafts and seal any gaps to retain heat.…
-
New Injection Press Setup
Setting up a new injection molding machine is a critical process that involves several steps to ensure efficient and safe operation. Before setup, get as many details of the job and the machine as possible. An idle machine is a waste of time and money.
-
Part Diverting Systems
Automatically Sort Bad Parts From Good Parts 3/25/2024 General Description: A part diverter is used to change the direction of a shot of parts, the discharge of a complete cycle or cycles of parts from an injection molding machine. IMS offers two different styles of part diverters (also known as “part discriminators” in the injection…
-
IMS Lime Buster
The Original Water System Descaler and Lime Eliminator! 3/2/2023 Use as mold maintenance or when a mold is removed from storage. Descaling mold water passages (channels within the mold through which coolant flows to control the temperature during the molding process) is an essential aspect of mold maintenance in injection molding. Over time, these passages…
-
Plastic Granulators
Granulators (sometimes referred to as grinders) are machines used to reduce scrap plastic parts or other plastic waste into a reusable form. This material – regrind – is sometimes put right back into the process to create the same parts. Other times it is reprocessed and re-pelletized for reuse. Occasionally material is turned into a…
IMS Company Blog 